A recording plays in only one ear even after conversion. Before changing formats again, compare the original through the same playback setup. A stereo file can contain a silent channel; two channels alone do not prove that both contain the intended sound.
Separate the file from the listening setup
Our suggested first check is to play a known-good recording through the same headphones and application. Then compare the source and converted file. If only this recording has the problem, inspect its left and right channel content in an audio editor.
Do not assume a conversion caused the issue merely because it was first noticed after downloading. Keep the source available for that comparison.
What this converter controls
Mediabunny separates output channel count from codec selection. Its documentation describes mono as one channel and stereo as two, with up/downmixing controlled by the requested channel count. FileMyLove's current audio converter supplies no such request and exposes no mono/stereo, balance or channel-routing selector.
| Finding | Suggested next step |
|---|---|
| Source already has a silent side | Inspect or repair channel routing in the source audio editor |
| Both files play correctly elsewhere | Review the original playback setup |
| Recipient specifically requires mono | Export with explicit channel controls in an audio application |
| Only the converted copy sounds wrong | Keep both files and return to the source before another export |
Selecting a higher MP3 bitrate is not a left/right repair command.
Check before delivery
- Listen to the original and note which side contains the intended speech or music.
- Inspect channel content in an editor, not only the stereo label.
- Prepare a corrected source copy if needed and listen again.
- If format conversion is still needed, use Convert audio.
- Listen to both sides of the downloaded file before sharing.
The website does not decide whether the intended delivery should be mono, duplicated audio or a preserved stereo mix.
Channels are not alternate tracks
Different languages stored as separate tracks are another issue: see multiple audio tracks and MP3. If the requirement concerns Hz rather than left/right content, read sample rate before delivery. Check each requirement independently.



